Cypress Semiconductor CY7C292A Manuel d'utilisateur télécharger pdf (Page 13)

3. Part is now programmed. If there were any errors during the

process, PGMX will abort with an error message back to the 9000

command mode. Be sure to look at the checksum to see if it is what

it is supposed to be.

4. To repeat the process, insert a new part and type Control–F and

then press the “F3” function key, which will give you the previous

command line that was issued which was FILENAME [tn,u,me.

Pressing <cr> now will cause the process to begin again.

You SHOULD read the rest of the manual to get specific details about

some of the operations performed above, specifically the COM-

MANDS chapter, the DIAGNOSTICS chapter and the PGMX chapter.

Chapter 2 Getting Started Quickly Model 9000

Page 8

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 93 94

Pas de commentaire

Cypress Semiconductor CY7C292A Manuel d'utilisateur Page 13